Recent content by 4th_Dimension

Yes sir, sounds good

Thank you all for answering back,now that I have some ideas I will be doing the (one long screw and the gummy’s and a lock nut and aluminum standoffs as needed). this not only will look nicer BUT offer better support. I will use a M3 long screws my stack I will be using these things... -i...

Maybe "nail polish" would work as well or better then "lock tight"

Good evening everyone, So I just laid out my build (per-build), you know layed out wires,ESC's, PDB & FC, frame together, Motors, camera....etc Looking at what I need to "soft mount", where to cut wires nothing is set in stone yet. But i dawned on me when looking at my build. How the heck am I...

Thank you all for the help

So my next question is...how do I gauge/measure the "pitch of both of these props? As you see WinDancer pitch is (3.5) & Hurricane pitch is (Supposed to have a pitch of 4.33")

Gemfan WinDancer 51433 3-blade 3.5 Inch Propeller Type: 51433 Blades: 3 Pitch: 3.5in Material: PC Weight / g: 3.8g Center Hole Inner diameter: 5mm Prop Disk Diameter: 129.72 Center Thickness (Center Thickness) 6mm Max Prop Width: 14.28mm Adaptive Motor: 2206-2306 Recommended Motor: 2206-2300kv...

I run 4-5S batteries

Lol, it's all good sir. Your help is always welcome and you are very informative

So 100rpm more is bad and I will have horrible thrust? I don't think so but you guys would know

Good morning all, So really fast one here... The props I just bought have a (Recommended Motor: 2206-2300k). Well my motors run 2400kv do any of you see a problem with this? Every other spec for these pros my drone has. Thank you, Brian

Thank you guys for the needed information. I don't fly (4in 1) ESC's. I have 4 individual ESC's. So I am thinking up go to 470uf/35v each OR I could go 1000uf/35v. Maybe over KILL 1000uf/50v. https://www.amazon.com/gp/product/B073YQJ1SN/ref=ox_sc_act_title_1?smid=AGNQZEOF5D5M3&psc=1...

Good evening all, So I am doing my build and upon reading spec's for my ESC's the Manufactures states that i should use 220uF - 330uF low ESR capacitor per ESCto absorb BEMF switching noise and overall better flight performance. What if I went just a little higher then the 330uF low ESR...

Thank you sir for the much needed help!!

Good morning everyone, So I am finishing up " 5" BEAST build" "Freestyle" flying I will be doing. I am trying to figure out a few things here before I Fire her up...... so if anyone can help out it would be AWESOME. 1>) I can run (3S-6S) for my build but how do I figure out how many "mAh" for...