Recent content by bmw546

i cut the long cable of my receiver specktrum ar610. (Like in the first 1/3 of the cable)

I finally solved the problem. Look like i didn't address correctly the servo and the motor. You just have to follow the tutorial and put these line when you can see in the motor tab the servo are moving when you move the quad: resource motor 1 none resource motor 2 none resource servo 1 a8...

The board is a afro flight rev6 (naze 32) on cleanflight configuration. and i think it use cPPM (one wire from receiver (orange receiver from hobbyking this one : OrangeRx R615X DSM2/DSMX Compatible 6Ch 2.4GHz Receiver w/CPPM ) to the board) This generation of board are starting to get old ...

Hi everyone. I have tried many time by following this video : (an the manual of the board) to make a single servo gimbal on my naze 32 acroflight rev6 I checked the box for the servo gimbal, but when i connect the servo to pin 1 it goes full on way(and eventually get hot) and i lose one...