Recent content by Jadawin
-
J
Strange throttle response
I set a mode in Modes tab and when I arm it I see as like in attached image.... I guess is ok because when connected to BF is disabled... ehm.... I guess it was right the MODE I haven't set !!! haha now it works Thank you again HighTechPauper!!! Jadawin- Jadawin
- Post #8
- Forum: Flight Controllers
-
J
Strange throttle response
Aaaaaaaahhhhhhh found it! Didn't see that "Show log" since it was kinda invisible haha... Anyway enlarged log panel and tried to check arm and trying rising throttle up but no errors nor warnings showed in log panel... maybe with BlackBox should get more log details?...- Jadawin
- Post #6
- Forum: Flight Controllers
-
J
Strange throttle response
Hello HighTechPauper... no in fact I get MSP flag when it's connected by cable to BF, also I get RX_FAILSAFE when I have my Taranis's off... Anyway about logs you mean BlackBox? If yes , I tried to set this blackbox with a microSD card then setting BlackBox page and then adding a mode range to...- Jadawin
- Post #4
- Forum: Flight Controllers
-
J
Strange throttle response
I tried whatever I could do to make motors start, I tried also to create a new model profile in taranis to set clear ranges and also I tried to reset betaflight to default settings and settled everything again with care to be sure they should follow Taranis on min 1000 - mid 1500 - max 2000...- Jadawin
- Post #2
- Forum: Flight Controllers
-
J
Strange throttle response
Hello everyone! I built a quad and it was working ok, then two days ago I just updated OpenTX on my Taranis X7 Q's receiver from version 2.3.9 to 2.3.10. I have a fc Mateksys F722-SE programmed with Betaflight. But I got a little issue that got me stuck and I hope you could give me a...- Jadawin
- Thread
- Replies: 7
- Forum: Flight Controllers