Recent content by Jocko

FC. GetFPV overnighted me a new FC and, BAM!, good to go! I really appreciate you taking the time to troubleshoot the issue with me.

Yes, it has been calibrated. I can't tell if it's 2 long and 3 short or 1 long and 3 short. I'm going to walk away from this for now and see what GetFPV can do. Thanks again for your time. I'll let you know if/when we find a solution.

# dump # version # Betaflight / STM32F7X2 (S7X2) 4.2.6 Jan 5 2021 / 19:08:42 (a4b6db1e7) MSP API: 1.43 # config: manufacturer_id: LMNR, board_name: LUXF7HDV, version: 8f0c8286, date: 2020-08-18T22:02:36Z

Not in the video.

Here is a vid of the blinking blue light. It's hard to say... 5 short but can't tell what it's doing after that.

Nothing when I try arming.

Three short upon plugging in the battery and two long, like in the attached image. beep beep beep beeeeeep beeeeeep Red light is constant and blue light flashes.

Plug in the battery, try to arm with the arm switch then immediately attach the USB and look at the arming status flag. does it still show nothing? No flags. Check the values of your throttle when it's all the way down. What is the number for your throttle? 998 What is the "Stick low"...

The FC powers on but the DJI Air Unit does not, unless I plug in a battery.

This was all setup by GetFPV.

I am unable to connect to the drone without having the battery connected. All aux channels are mapped correctly and work as they should. The 'tic' is well within the slider value for all aux modes.

Interesting. This is the only way I've been able to get the motors to come on. Are you in the 808?

Under the Motors tab in BF, you have an option to power up your motors. Now you can arm and spin-up your motors.

Yes, I can arm in BF, disconnect from BF and fly. I did this yesterday with props on and hovered in the backyard for a few minutes. I don't have the props on anymore but I can arm in BF, disconnect from BF and the USB and it works as it should. I can disarm and rearm fine. BUT, when I disconnect...

# status MCU F722 Clock=216MHz, Vref=3.28V, Core temp=45degC Stack size: 2048, Stack address: 0x20010000 Config size: 3962, Max available config: 16384 Gyros detected: gyro 1 GYRO=MPU6000, ACC=MPU6000 OSD: MSP System Uptime: 54 seconds, Current Time: 2021-02-23T18:37:45.753+00:00 CPU:2%, cycle...