Recent content by Keifie

A little late to answer but yes you can swap the receiver and start using the T8 with the Diatone

Very good! Nice flying and production

Which race drones did you build? Welcome to (IMO) the best addiction available

Totally Insane but Sweet!

Maybe look in your area for ads for used items such as the goggles. Or maybe put an ad out yourself looking for good, used DJI goggles to trigger a response

•GitHub (Betaflight) You will need to find out which flight controller is on the bird. Install Betaflight configurator on your computer. Flash the flight controller after you have connected to Betaflight. After you flash your FC you will have to set it up. There are tons of YouTube videos to...

OlafFPV has a product you might be interested in. That kid came up with a brilliant circuit board few years ago that can switch between two RX'S. Maybe you could start there and get some ideas

yes

Turn off the accelerometer and turn on air mode. Fly acro and that should take care of it. Good luck!

Of course the “FPV know it all” Joshua Bardwell is where “you’re gonna learn something today”. He and countless others on YT is where I started and still go for all questions FPV. I think you’re gonna enjoy the ride. Welcome!!

Had this exact issue with the HolyBro F7 HD stack. Right out of the box, twice, motor #4 esc intermittently sent signal. Now using same drive train without HB esc. Tmotor F55A PROII went into this build and another. Haven't had any issues after a couple months now. HolyBro makes good products...

How is she flying with this set up? I've got the same motors> BH Avenger 2507 1500kv V2, but haven't even started my Raggio build yet. I have planned the time to do it tomorrow. I have a RunCam Split mini that I had laying around. The STL file for that 3D printed pod (for Raggio) is available...

Try this forum> 3DRpilots.com

Very nice looking build you have going on there. Is that the iFIght frame? I just ordered the Raggio frame for my first long range build. It will have a UniBlox m8 GPS that I found laying around from 2016. What size BrotherHobby motors are those?

@Fpvracer-Looks like its gonna be a fun one. And don’t forget to check for direct shorting with volt/ohm meter or “smokestopper”