Recent content by Marijn

You just can't stop giving good advice, can you? Thanks a lot!

The smell is only noticable when I hold my nose about 10 cm (4 inches) from the ESC by the way, so the smell is not super bad

Thanks so much! The only thing that is still happening is the burnt smell coming from the ESC after I connected the battery to the drone. Is that a bad sign?

I also thinking of using 4 single ESC's instead of the 4 in 1 esc in case this happens again.

Hello, I'm building a new quad and have some problems with my 4 in 1 esc. I wired my esc up to my motors and fc and I got all the motors to spin. But I smelled a bit of a burnt smell after unplugging the battery, coming from the esc. After plugging the battery in for some testing for the motors...

Thank you, however I live in The Netherlands so I can't just buy ammunition boxes at my local supermarket :). I think I'm going to buy a lipo safe bag to store them.

Thanks for the info!

Hello I have some questions regarding my lipo batteries. I've used my battery is the pictures for quite some time and it has swollen a bit. Do you think I could still use this battery or should I throw it away? Also, how high can the difference in voltage between the individual cells be to still...

Hello, I would like to upgrade my fpv video quality, but I don't know which part is the weak link that I should upgrade. This is how it currently looks: This is my current fpv setup: - Vtx that came with my eachine wizard x220s (Eachine Wizard X220S FPV Racer Spare Part 5.8G 72CH 25MW 200mw...

I have a ohm meter on my multimeter. Tomorrow I will figure out how it works. I live in the Netherlands and I'm guessing you're from the usa? Anyways I think we could Skype or something that would be an enormous help I think.

Between yellow and red: no voltage Between green and red: 16v between blue and yellow: 16v between blue and green: no voltage

So the small black wire you resoldered went to where the yellow highlight is?: Yes And between the blue X and the yellow highlight are you reading battery voltage?: Yes, around 16V Also check for voltage between the blue X and the blue circled pads, do you have battery voltage there?: No But I...

Ok, so I soldered the black wire to the FC and it worked, because the receiver works. But when I measure the voltage on the FC between these two pins, I'm getting 0 volts.

Thanks! I will try this in a few hours

And also, do you think I'm able to solder the wire? I haven't really got a lot of experience soldering.