Recent content by mesasys

Looks like NIWT 50g refers to the weight or amount of solder. Here's a photo of my soldering station. You can find them on the webs for around $70. I use 110v. My unit has interchangeable tips and a hot air gun. I use the hot air for shrink tubing.

Based on the CF-10A data sheet, soldering temp: 270-350C. Keep solder tip clean. Tinned iron tip before use. I suggest you experiment or practice on the damaged board before trying again. I also use a liquid flux on the pads even though the solder has flux built in. Soldering time is 1-3 secs...

Interesting. I never thought of that one. I was thinking more along the lines of the unit overheating if the unit couldn't find the goggles. Luckily I flew it with the antenna on. Thanks!

Thanks guys. Just being extra careful not to damage anything too soon. Goggles are on the way, but it's nice to know I can fly line of sight without damaging the system.

Hi all, I'm not a newbie to RC flying. However, I'm new to FPV. I have a Mark4 quad. It came with a FPV system. I believe it's the Caddex Nebula Nano. I don't have the DJI goggles yet. After going through Betaflight setup I was able to hover the drone for a test flight. I'm concerned with flying...