Welcome to FPVDronePilots!
Join our free FPV drone community today!
Sign up

Recent content by NavyQUAD250

  1. N

    Packed that purchase back up and sent it . Top builder said it was death trap

    Packed that purchase back up and sent it . Top builder said it was death trap
  2. N

    New builder troubles

    Gotta go 4:40 is early, Hurrah
  3. N

    New builder troubles

    Turns out I already adjust but low low is 1000
  4. N

    New builder troubles

    I have an older dx5 controller but yes that makes lots of since
  5. N

    New builder troubles

    Tried to add picture but having trouble. But minimum throttle is 1095 maybe why it runs away
  6. N

    New builder troubles

    On configure page or PID ,
  7. N

    New builder troubles

    Check back tomorrow night I will post results
  8. N

    New builder troubles

    I will speed up the throttle trim but it will not arm after too high setting, right?
  9. N

    New builder troubles

    Now that makes since
  10. N

    New builder troubles

    Im new to this but plastic studs
  11. N

    New builder troubles

    Fc is plastic stud mounted
  12. N

    New builder troubles

    Angle strength 75. Over 40. Transition 40 Limit 55 sensitivity 40 Throttle mid .50 TPA .15
  13. N

    New builder troubles

    I am running version 3.2.2 PID settings: Roll 40. 15. 10 Pitch 50. 30. 10 Yaw. 60. 40. Rc rate 1.74. Over. 2.00 Super .50 .55 .12 Expo .12. Over .10
  14. N

    New builder troubles

    First thanks for trying to help me. The air mode is cut on and off with nothing noticed. Matter of fact I changed it to on by training lever, meaning o have pull the switch to cut it off.
  15. N

    New builder troubles

    PID Settings are one thing but oscillating causes throttle runaway and low stick drop out when Power cut completely out. Anyone have this happen? It’s a new arf and I like it just can’t hover to smooth landing runs one direction, up.
See more