Interesting. In Canada you can fly 100’ above the structure as long as you fly within 200’ radius of the structure.
See 901.25(1)(b)
https://gazette.gc.ca/rp-pr/p2/2019/2019-01-09/html/sor-dors11-eng.html
Welcome to the forum!
This definitely won’t be repaired. I had an accident with my DJI FPV about 2 weeks after purchase. Not nearly as much damage and the quote for repairs was higher than a replacement with care refresh. This was the extent of my damage:
I emailed them, as well, at initial release of the Nanuk 925 for DJI FPV saying they should make a larger case to hold more batteries. I didn’t get a response though. They would be wise to get on it quickly
The MC-Cases dimensions that were posted earlier in the thread are similar to the INTERIOR dimensions of the Nanuk 945. If those MC-Cases dimensions are exterior the foam will likely be too small for the Nanuk 945
**********EDIT**********
MC-Cases EXTERIOR - 21.85 x 16.85 x 8.31 inches
Nanuk...
Not sure if those are interior or exterior measurements but the Nanuk 945 interior measurements are 22x17x8.2 inches. It’s a fairly large case but doesn’t really bother me as I have no plans of taking this case on a plane. I may look for a small bag or back pack later to use as a carry-on.
That’s pretty cheap. With Nanuk, the foam is, typically, just as costly as the case and for some models, more costly. For example, the Nanuk 910 case is $79CDN and the Mini 2 foam insert is $86CDN or the Nanuk 910 with Mini 2 insert is $129CDN ?♂️
Will do! Mark, the sales manager at OVT had this response to my question of ETA:
Not yet. They are going back to their redesign process and told us that they’ve looked into the whole problem. Please check with us again by next week so that we can also do the same with them in order to expedite...
I’m sticking with the Nanuk 945 from OVT. Hopefully they will nail it with the revamped foam! The drone fits perfectly with props on btw, and a simple modification would accommodate the arm braces.
I didn’t get a response on ETA for the updated foam but I did get this (poor service, screenshot won’t load):
Thank you Richard. You have our full support as we have a strong partnership with the manufacturer when it comes to the design and guarantee of these cases.
It’s one of the reasons why...