Recent content by psybersapien

I was building a Geprc Cinelog35 V2 and it didn't seem I could fit the right size capacitor in the area they gave in the frame. So I was trying to think of alternatives. As it turns out, there is a small "notch" in the stack area where, if I solder the cap to the power pads on the AIO I have...

Good to know! I'll find a way to solder the capacitor directly to the ESC power pads. Appreciate the feedback!

Understood. I'm rethinking the capacitor installation location after I've been able to put together a prototype with all the main parts I plan to use in the build. But it's good to know this approach is feasible. Not optimal but, as you say, better than nothing.

I'm secretly hoping your emoji was because you're kidding. 🤞 May be needless to say but it's metal on metal so I didn't think I needed the solder joint.

I recently purchased a Geprc Cinelog 35 v2 frame. If you've also done so, you know there is no manual describing the frame build or the parts. I can deduce where most parts are used but don't know where the "crimp nuts" are used. Does anyone happen to know?

Will a capacitor installed on the battery wires to a 4-in-1 ESC work as expected (picture below)? I can't use the typical install locations on the solder pads or on a XT60 WaFL board.