Recent content by ScottyFpv

Hey guys, I'm from the Orlando area. Been flying Fpv since October 2020. Loving the experience so far.

We think a like I guess. I did exactly this for the time being. I'm going to order a new plug off amazon. I've never messed with removing pins/building plugs with wires. I'll look into it, as I'm sure this won't be the last time I have this problem.

For anyone interested, pre-orders are back on RDQ's website. https://www.racedayquads.com/products/dji-digital-fpv-goggles-v2-ultra-low-latency-810p-144fps-digital-hd?variant=32274971983985

Does anyone know where to solder the video wire for TBS Unify Pro32 HV? The video wire on my plug got cut inside the plug so i can't repair it.

I made this short video on how to resize any stl file for your quad. Just learned how to do this today, there may be a more precise way of resizing..but this is quick and easy, and it works!

I did that. For now I'm going back to spectrum, not worth breaking parts over..

My tracer setup is constantly saying low rssi, like 8 low. Always now. It fail safe twice. Not sure whats going on. I'm pretty new to crossfire.

This is to help anyone else. Turns out channel 3 on my transmitter was low out of range causing failsafes to acure. This is why roll and pitch would work intermittently unless throttle was over a certain value. I fixed this by setting the command "rxrange" in CLI, then picking channel 3...

Not sure about the fw numbers. They should be the same as this is a brand new TBS product Tracer. 2.4ghz low latency. I got it to arm randomly while messing with it..it was truly random too.. hasn't done it since.. I'm in contact with support.

Hello, I'm completely new to crossfire and TBS in general. Setup was super easy and binding worked fine. In the receiver tab of Betaflight, I see Throttle working smoothly, however Roll, Pitch and Yaw don't seem to work or work intermittently unless i'm moving the throttle at the same time. When...

I thought about...But I'm glad I didn't break it haha

I got it to work. This is for anyone else having this issue. Hopefully its a help. First Solder the signal wire for your DSMX receiver to RX6 Next Change UART 6 in Ports tab to check serial RX Next Change Serial Spektrum receiver in Receiver mode in Configurations tab Then Change Receiver...

I can't for the life of me get my DSMX to go into binding mode. It has power, the signal wire is hooked up to the SBUS port. Ports tab has UART1 checked for serial RX. Configuration is correct, 2048 for spektrum. Type in cli command " set spektrum_sat_bind=9" save. Board reboots. Unplug usb...

It was the VTX, bought a new one and I have video now. My new problem is getting this pesky DSMX receiver to go into bind mode...grrr. I'm following the guides but it doesn't want to go into bind mode..