Recent content by TikiFPV

Its been raining in san diego, so all ive been able to do is hover and navigate around downstairs, but she seems responsive. just have to wait for it to dry out here SIGH...

OK checking back in, finally got the taranis talking to the bird and confirmed through betaflight, I had to set UART2 to MSP, and UART3 to serial. Got my fatsharks unboxed, and my 5GB reciever set to "race" not sure if that is correct or not, but im getting a clear picture. Now I have to tidy...

ok so im back to where I was before, having issues on the receiver page of betaflight. the inputs are all static and not moving when i toggle switches or move the sticks on my taranis. the rest of the setup is going smoothly.

YAHTZEE BOYS!!! we have successful reflash. I swapped out to ANOTHER USB cord, and I set the thing to autoflash as soon as connected, AND held the boot button THE WHOLE TIME it was flashing and it was successful. now Im back into betaflight and ill be following the setup instructions we...

tried flashing it, got the error no response from bootloader

video requested:

just reinstalled and restarted everything, zadig shows the board as CP210 to UART. betaflight still cant connect, same errors given

just confirmed, when I connect the board in bootloader mode, it shows CP2102 TO UART bridge controller. Thinking outside the box here, what if the UART port that is the usb got switched to off or serial when it rebooted the board, could that be why its not communicating? and if that was the...

when the GT2 WAS talking to betaflight, I never saw VCP in the ports, it was only ever UART1, 2, &3. So I dont think the Zadig process will help since i think this quad is on a cp210 chip (as the video describes)

Thanks for the info thus far Jerry, I searched that thread and didnt find anyone that had my exact issue with the communication failure.. just for reference this is what I am dealing with

tried all of the above. still no joy. totally frustrated. tried new computer, new usb, reseating the usb, using the boot button, not using the boot button

I did, same result

That guide didnt work for me :( I got no response from bootloader

Watching it now

Also- side note, the black plastic connectors on the ends of the wires that came on the harness for the GT2, I am to just insert the bare wire ends into them from the harness for the XSR, right?