Recent content by wibo33
-
W
cannot callibrate
My firmware is Betaflight _3.1.0 I see the CLI commands are different from older firmware. I have to set it to Default(is on, "0"). Unfortunately it did not solve my problem.- wibo33
- Post #9
- Forum: Flight Controllers
-
W
cannot callibrate
very confusing indeed !! set acc_hardware = 0 zero is an invalid value ! set mag_hardware = 0 invalid see; get acc get mag- wibo33
- Post #8
- Forum: Flight Controllers
-
W
cannot callibrate
They were not enabled. I enabled them but there was no difference. So it did not solve my problem.- wibo33
- Post #5
- Forum: Flight Controllers
-
W
cannot callibrate
OK, Please tell me how do I know or where can I see compas is enabled or shut of ?? Sorry but I am not familiar with the firmwar !- wibo33
- Post #3
- Forum: Flight Controllers
-
W
cannot callibrate
Recently I flashed the Betaflight firmware to my Flip 32(REV5, 6 DOD) board. The flashing procedure was succesful. I connect the board, there is connection. Now in the SETUP I want to calibrate the accellerometer., the colour of the yellow block turns into white for a very short time. Then...- wibo33
- Thread
- accelerometer callibration flip32 magnetometer naze32
- Replies: 8
- Forum: Flight Controllers