Recent content by Willanoob

Hay just wired up same issue one motor stutters motors won’t spin

Just ordered a new stack ??

Just tested the harness it’s fine Did notice when I arm sometimes one motor jitters a little

In the googles it says armed and in the motor test bit when I move the sticks I get a response on screen as if thay were being powered I have already used the 2nd esc to fc wire to try it out and done a continuity test from The fc to the esc on the harness

I’m using a mamba f405 mk2 stack from a pnp diatone gtr mk3 Bought it recently as my first 5inch when I first plugged it into beta flight I could use the Motor tabs test thingy and spin each motor when I had the Lipo plugged in. I have since updated the firmware and connected a spm4650...

I put a new wire from esc to fc to be safe and the fc is doing everything else the fc should do still same issue

Also esc goes do do do then no do do ( beep )

Hay so I can’t get my motors to spin even when armed

Hay I’m having an issue connecting my rx (SPM4650) I Have it soldered to the tx3 pad on the Mamba F405 I have updated beta flight and still doesn’t work I’m quite new to this and don’t quite understand it all plz help