I am using the XILO Stax Combo - F4 Flight Controller. I am trying to make it totally plug and play. So I thought I could add a servo plug to the end of the receiver wiring harness and solder header pins to the board but the holes in the board are too small to except the header pins. It appears that these header pins only come in one size? Any suggestions?
The harness supplied with the FC is a 5pin Molex pico blade 1.25 (I think)
I would like to also connect the video transmitter and camera connections the same way.
![20210111_143901[1].jpg](https://fpvdronepilots.com/data/attachments/4/4793-be21f338b0344e2753172ba31772ba97.jpg "20210111_143901[1].jpg")
![20210111_143846[1].jpg](https://fpvdronepilots.com/data/attachments/4/4794-3c2f25f0f4e2c868d2c4e8eae51c68ab.jpg "20210111_143846[1].jpg")
![20210111_143756[1].jpg](https://fpvdronepilots.com/data/attachments/4/4795-decad77d7389d6f8b442db19511682a3.jpg "20210111_143756[1].jpg")
The harness supplied with the FC is a 5pin Molex pico blade 1.25 (I think)
I would like to also connect the video transmitter and camera connections the same way.
