Hey guys, this is my first time building a drone, I have some experience with planes but i know building a drone for a school project. I have a Naze 32 acro 6 rev flight controller, I am having so much trouble trying to set this up and get it working, I’m using cleanflight and I always get the same three errors, “Failed to open serial port” which I have reinstalled the drivers for and my computer recognises the flight controller and assigns it a port, “STYM 32 error” I have installed the STYM32 software and this still occurs, “cannot contact boot loader” I’m not too sure what to do about this one, all these errors occur when I try flash firmware and yes I am using a stable version. I’ve even tried shorting it out with the boot pads, I still can’t get it to work, is it just dead or am I doing something wrong? Thanks !!
