Recent content by BTLABS

Jerry, This might be my problem. I will check this. I have been reviewing Josh Bardwell videos on this issue and think this may be my problem. Also, I have noticed that others using Flysky have reduce the resolution of the sticks from 1000 (2000-1000) to 800 (1900-1100). I am not sure why this...

Yes...does not work.

Yes. Motors spin up fine in Betaflight. I calibrated escs.

Thanks, Just tried this. No response.

Tried this...no help

Will check solder connections again with meter. Everything is direct wired to save space and reduce possibility of disconnection. I will try soft mounting with o-rings. I assume you are referring to motors twitching.

Thank you. Will recheck solder connections.I direct soldered allco

Using Flysky's AFHDS 2A protocol with older Flysky FS-i6 and new Flysky X6B i-Bus, PPM, PWM receiver set up for PPM. Receiver bound. The receiver controls are operational under Betaflight 3.0.1. Escs are calibrated. Channel 5 is mapped to AUX 1 for arming. Under Betaflight, I can see switching...