Recent content by Kestrel76

Hi all! Today my quad crashed after wrong activation of gps rescue mode. I found it and verified that no damage occurer. But I could not arm the quad because the binding seemed lost. I double checked the cables and continuity of each. The stranger thing is that the receiver (XM+) would not go...

Now I know. I saw a misleading video on YT. Thanks

I wish to share with all the resolution of my issue. Due to the fact that its very difficult to downgrade the OpenTX firmware I just managed to do a last try. Instead of flashing the XM+ receiver with the normal old XM+FCC170313.frk firmware I selected the old XM+FCC170313-RSSI16.frk and bingo...

I have a Taranis X9D. Tried to flash the internal module with both FCC and LBT firmware, but didn't resolve the binding issue. Battery voltage is around 8v

Can't I just flash the internal module instead of flashing the receiver (It will be simplier: I know there is the chance to over energize the xm+ with the transmitter battery and burn it)? Or is It a problem relating also to the firmware age?

Thia means that you had to flash the receiver?

I definitely wrote in bad english. Mine were two different questions: 1) what is the meaning of the red and grey dots? If I solder on the second row I'll get different out puts? 2) This is a question to which I already received an answer: Tramp and camera (Foxeer micro toothless 2) can be...

Hello everyone! I'm new to the FPV world and purchased components following some tutorials on YT. Mamba F405 mk2 stack came with a schematic that didn't quite understand: How does those red and grey dots be intepreted and ... ...should I power my Tramp HV to 5V, 9V or VCC (as some video I've...