Recent content by Kspearson1

The correct motors spin when prompted in BF. I’ve never done bheli before so I’ll have to look into that. Nevertheless the video should confirm the motors are spinning in the right direction.

Made a short video. I’ve since tightened Up the props but that didn’t seem to solve the issue. I recalibrated so it doesn’t think it’s sideways. I’m wondering if my incredibly crappy solder job would have anything to do with it. Although that wouldn’t explain why the motors work correctly when...

Yes the orientation in BF corresponds to the correct correct movements. I’ve gone thru each individual motor in BF motor tab as well as slo motion video to confirm the props are spinning inward (4 and 1 CW, 2 and 3 CCW) and the props are installed to have the leading edge go first. Is there an...

Any ideas on my Tyro 99? I re-wired the motors and confirmed they spin inward. Motors with the black/silver nuts are opposing. When I spin the motors individually in BF all is good, but when I go outdoors with the RX, it’s haywire. It freaks out and I can’t get it off the ground. I tried...

Anyone have a workaround for a inoperable bind button? RXSR. Tried poking the area with a pin but doesn’t seem to work.

Port setting looks good according to manual. From where I can see the green wire is soldered on but maybe I’ll undo some screws and take a look

Anyone seen this before ? My RC is showing connected , but Betaflight won’t accept stick inputs. RC Failsafe turned to OFF

Anyone heard of Error RX_Failsafe MSP? UART set at Serial RX

Tyro 99 RXSR bound, but not recognized in BF. I’ve got the blue and green light and the controller says it’s bound. But when I connect to BF, it’s like there’s nothing there. Any ideas ? It worked yesterday and I was messing around trying to get the motor changed but nothing with the RX.

*Help* Attempted Tyro99 flash and got a bootloader error. Now it won’t connect in Betaflight. Mac computer, re downloaded some of the drivers and tried ImpulseOSD to restore driver. It connected and configured just fine before the stupid stupid stupid firmware flash (out of dates fly better...

Turns out it was actually bound. The transmitter receives power only from the Battery so when I hooked it up to the USB without battery it didn’t transmit anything making me think it wasn’t bound. But once I plug the battery in and then plugged into the USB all was good. Side note; I started...

I just got the baby hawk pro 4. I was able to bind it with my FrSky Xlite in D8 But when I remove power and plug it into beta flight still bound, beta flight doesn’t recognize the quad as being connected Is there some setting I am missing ?

I just got the Mobula 7 and it’s extremely squirrelly! I scaled down 50% but I can’t casually fly the thing to save my life! My Mobula 7 (FrSky Xlite) has this annoying quirk; when you’re not actively moving the throttle, the engine cuts out. I confirmed AIRMODE is activated and it shouldn’t...