Recent content by Primoz_Horvath

I found it. the wire was connected to tx and not pwm of the esc.:rolleyes:

Hello, I start with a new Chameleon built with 4 separate esc's.( Holybro Tekko32 F4 MCU BLHeli32 45A ESC Dshot1200) Now, after connecting esc's with FC, I get only first 3 beeps. I have no clue how to troubleshoot. Is 1 esc malfunctioning or do I have to change something in Betaflight? I only...

Thank you for the extensive reply. I won't bother too much getting sandpaper,lead free stuff and so on. I have some spare vtx that I can use, and which I just installed tonight. But I guess the solder pad is gone. (Cause I only saw a tinny dot and now its al gone since I have been scratching...

This is probably the case. there was only a small dot, I could hardly see it.

Now I have a similar problem. I have a vtx and the antenna connector broke of. I have another antenna from which the connector was also broken of, so it was time to solder the antenna directly to the vtx, enough videos which show how to do it. Now, it is impossible to solder onto the antenna...

ok, thanks, yeah maybe it is brass. But I'm not in a hurry to use a torch so close to an electronic board. But I somehow managed to solder it a bit, its connected for the moment. But I have a second goggles, my backup plan.:)

Ok, thanks mate! I didn't go to youtube to watch the video, hence, I missed all details. But now I did, I think I will start with a diy battery pack and see what that gives! thanks for the info and good luck! cheers

Hi, nice content. I would also like to go long range flighing. I would be nice to get some more insights about the drone. Like what batteries/vtx/fc and so. How long can you stay in the air? And how far can you go?

Hi, I have a fatshark goggles with nexwave rf 5G8 module. The coppercolor part from the antenna has broken of the board. I try to solder but without succes. The solder does not stick to the copper part. Maybe it is not possible to solder to the copper? Do I need special solderwire for the...

ok, I updated my esc's (I didn't know I could do that untill today!:p) The beeps are gone now. Better late then never.

Hi, yes, I have osd. I changed the camera (runcam) and the problem did not occur anymore. Maybe something broke after the drone has been 5 minutes under water (no salt water)? I will check everything you mentioned, thank you.

Hi, so, turning on the drone + goggles, after a while (30-60seconds), the image starts to stutter and then a black screen. I disconnect and connect the battery of the drone and I have image again, for some seconds. When I get the drone in the air, I do not get black screen, but good image and...

ok, but I like to assemble and disassemble my drone now and then. Won't I have a hard time with all this glue?

ah ok, now I see it! Very convenient when you have been messing around with those wires!;) I'll give it a try next time. thank for all answers! cheers

@MMightywren @Chris_A Do you mean you glue your plugs from fc to esc,vtx,camera... Can you still unplug them later? Or is it just a tiny little dot in the middle of the 2 plug?