Welcome to FPVDronePilots!
Join our free FPV drone community today!
Sign up

Recent content by Samu

  1. S

    Really low rssi xm plus

    In the past I had problems where the solder joint on the rx were bad, the range was **** and it casually failsafe but this time the solder joints seems good, I haven't had a single failsafe, the range is pretty good only the rssi value is weird, however I will try to redo the solder joints
  2. S

    Really low rssi xm plus

    Did you find a solution?
  3. S

    Rssi problem xm plus

    Hi, yesterday after flashing accst 2.1.0 on my xm plus and qx7 I noticed that the rssi value was way off, when the quad is really close the rssi is at 80-90 and it seems normal but after just 20-30 meter it drops under 50 and i stard getting warnings, however this didn't impact the actual range...
  4. S

    Really low rssi xm plus

    Hi, yesterday after flashing accst 2.1.0 on my xm plus and qx7 I noticed that the rssi value was way off, when the quad is really close the rssi is at 80-90 and it seems normal but after just 20-30 meter it drops under 50 and i stard getting warnings, however this didn't impact the actual range...
  5. S

    vibration at high throttle

    The small bent capacitor pop out completely is this an issue?
  6. S

    vibration at high throttle

    OK I will give them a look, thanks for the help
  7. S

    vibration at high throttle

    OK since all the motors have bent shaft, motor mount and ruined bearings I will buy a new set, what motors do you recommend me?
  8. S

    vibration at high throttle

    I tested the motors and all of them made really bad sounds I think the bearings are dirty or damaged Some motors especialy one make more noise on the gyro but i think they are all pretty noisy In this video I spin the "good" motor as you can hear it doesn't sound good: So I need to change...
  9. VID_20200511_170951.mp4

    VID_20200511_170951.mp4

  10. S

    vibration at high throttle

    The props are OK i changed them. I notice that 3 motors have a slightly bent motorshaft (less than half a millemeter) do you think that they are causing that much vibrations? And switching from my 470uf capacitor to a 1000uf cap would help to reduce the video noise?
  11. S

    Possibly motor problem

    Check alla the solder joints I had this problem and was a broke solder joint of the motors wires
  12. S

    vibration at high throttle

    Hi everyone, I recently built my first quad: martian anniversary special edition 215mm frame, mamba F405 mk2 FC, F40 40A dshoot600 ESC, emax eco2207 1700 kv motors, one 470uF 35V capacitor, eachine TX805 vtx, frsky xmplus receiver, caddx turbo micro F2 and 6s 1000 mah batterys. After one hard...
  13. Quad

    Quad

  14. IMG_20200508_154207.jpg

    IMG_20200508_154207.jpg

  15. VID_20200508_153130.mp4

    VID_20200508_153130.mp4