Recent content by stefanpala

Hello. After a serious crash with mostly 0 flight experience, I dived in simulators and whatnot. Now that I love flying, I have bought esentially a new drone, except the frame, for a fresh start. Trouble is, two of the motors wont arm. They initialize, but that's it. Both in Betaflight and...

Thanks for the answers! I have almost replaced LiftOff with Rocket League so yeah, i'm practicing a bit haha. Appreciate it guys!

Hi. I'm new to tuning the rates, and I want to do cinematic flights with my 5" drone. I've noticed that if i put my rates at say 333degrees/s it moves slow and lazy. Do lower rates help a lot with overall cinematic flights?

Recognizing the piece is not a problem. Most of them have a code written on them. With a magnifier I discovered it says L315. Searched google for "l315 datasheet" and found out what the piece does, the pin layout, everything you need to know, and basically where to buy a new one and replace it...

I already have saved the config with "diff all". Mine heats up really bad from a short (I checked it) and doesn't open whatsoever. Turns out the L315 piece that is overheating is a voltage regulator and right now I'm looking for a new one to swap with this one. Still am not prepared to buy a new...

Right, I have no idea what it would be. Imma try and sort it out, I am not mentally prepared to buy a new FC yet. Thanks for the response, appreciate it!

Done that, disconnected the FC from everything, and it still doesn't connect and no LED pops up. Only that same piece overheats. It reads on it L315. Any idea what it could be?

Hello I've taken my drone out for a spin. Just to mention I have 0 experience with flying and couldn't get a simulator before I got too curious. It was a good flight, a couple of soft crashes, and all the controls and LED's were fine. Later when I got the drone clean, except for the beat-up...

As soon as I uploaded that response I watched Joshua's video on this issue. Performed a hover test and it went surprisingly smooth. As far as I am concerned, this thread can be closed, the issue has been resolved. To recap, A8S V2 (apparently I have V2) does not show on my radio, which means I...

Soldering's fine. My father didn't let me do it because it's so small, so he did it and he has over 30 years of experience in electronics. But yea, I configured it in iBus. 100% did not know that the A8S doesn't report back, so basically I will have to rely on my OSD feed to see when the battery...

First off, the I6X does not recognize the receiver with the appropriate RX battery display. On the other hand, the A8S is somehow bound to the transmitter because the LED is not blinking when the TX is turned on. If I want to bind again, rapid flashing by the A8S is followed by slow flashing...

Really new, with a Eachine x220 v2 ✌️