Recent content by Stijn

I am getting 0V on the 5v pin on the wiring harness coming from the ESC and the lights on the FC are very dim while on battery power so it probably is the voltage regulator. Is there a way to replace this or do I have to get a new ESC? Edit: I went over the information on my ESC and I'm pretty...

So I replaced the FC but it still won't communicate with the ESCs. The bat light does go on on the new FC but the RX doesn't power up on battery power(it does on USB power). Could it be that the ESCs are faulty?

Flying to a country with some strange drone import rules. Easiest thing to do was to turn it into drone parts.

I'm using the TBS crossfire nano. With the LiPo plugged the RX does not seem to have power and there is no light on it. In BF with the LiPo plugged in it sometimes says 0v and sometimes 3.7v. Moving the sliders in the motors tab has no effect on the quad.

thanks for the reply. I reflashed it but still only three beeps. The motors don't spin and the transmitter does not connect so I don't see how I could arm it. I did notice that in BF under power state it says that there is a 1 cell battery connected with a 3.7 voltage. Before traveling I did...

About a month ago I got a Nazgul5 and it flew great without any problems. However, I had to disassemble it to take with me on a flight and when reassembling it I made a dumb mistake and mounted the FC upside down which caused the micro USB port to slightly touch one of the solder joints between...