Recent content by wallin

Glad that his knowledge keeps spreading. My drone is now built and first flight went really well! I have now started working on the camera gimbal. Cleanflight has the funtion SERVO_TILT which outputs two servosignals. I've looked on tutorials and is almost able to sort it out. But all of them...

Thank you! Calibrated and problem disapeared! Thank you again!

Now the reciever works perfectly! But there came up another problem. When i have it still connected to the computer I can see the value each motor gets from the fligthcontroller. After I ARM it, they all goes up to ~1045, when rising increasing the throttle every motor increases its value...

Some forum said that it was PPM between transmitter and receiver and PWM from receiver. I got some weird issues. The channels aren't corresponding to the right sticks, i think throttle is on pitch for example, do I change that by swapping wires or is it a mapping issue? I also get readings on...

I've now build the drone and tried what you told me. It works! I have a Turnigy 9x reciever, it says on the controller that it's PPM. But in cleanflight it doesnt show my stickmovements. If i change it to PWM it shows. Is it some other settings im missing out on or is this how it's supposed to be?

Great, I will try that! Thank you again!

So I should solder 5V from the PDB to this positive row and then ground to any GND on the board?

Okey! Then I think I know how to proceed. Thank you for taking your time to explain it to me!

Turnigy 9x8C V2 I've only tried it while powering it with the usb-cable so far. I just watched through it, so I connect the 5V and ground from the PDB to those pads on the reciever-pin-row, as they power up the flight controller? Or is the input voltage to the flightcontroller supposed to go...

Yeah, that's why im confused if im doing it wrong or if i really got two bad ones. I've been measuring between these two points. Thank you for your reply!

Hello I'm building my own drone right now and ordered the naze 32 rev 6 from hobbyking. I've recieved it and started to test it out, when i tried to set up my reciever (Turnigy 9x) a problem started showing up. When plugging it in while the board still is only connected to the computer I...