naze32

Hello guys, i am having a rough time training to build a quad. While i wait for my own parts, i have a old quad here to train on and i had to swap out the ESCs. The quad flew fine before. Main parts : -F1 Naze 32 rev6 FC -Littlebee 30A ESC x4 with Bl heli rev 14.9 flashed on all 4 ( was 2x...

Having the board with only the usb connected to the PC I can see on Baseflight how the 3d model spins around yaw axis and Heading value drifting so hard. Check the uploaded gif see what I am explaining. I need that heading value because I am developing a software for an autonomous drone. How...

Hi everyone. I have tried many time by following this video : (an the manual of the board) to make a single servo gimbal on my naze 32 acroflight rev6 I checked the box for the servo gimbal, but when i connect the servo to pin 1 it goes full on way(and eventually get hot) and i lose one...

Recently I flashed the Betaflight firmware to my Flip 32(REV5, 6 DOD) board. The flashing procedure was succesful. I connect the board, there is connection. Now in the SETUP I want to calibrate the accellerometer., the colour of the yellow block turns into white for a very short time. Then...

Hi i got an afro naze32 acro flight controller, i want to use it to control 4 servo motors which are going to be used in a variable pitch quadrotor, do you have any idea about how can i move these servos with the naze?