So, been flying a drone with my AT9S transmitter and R12DS receiver. Got a second drone (different type) and bought a second R12DS receiver. 2 drones, 1 transmitter....nothing new there right?
I figured when I bound the second receiver it would show up as model 2 on the transmitter and I could add the name and set it up.....but nope. It still shows model 1(while bound) and I have stick control. I haven't tried turning on both drones to see if both operate on Model 1...assuming that should not be possible.
This is my 1st time trying to add a 2nd model to a single transmitter...I have a transmitter for each thing I fly....HA, a bit old school.
Trying to figure out how to get 1st drone as model 1 and 2nd drone as model 2. I need different settings for each. The manual for AT9S does not address 2nd, 3rd, 4th, etc. model binding and set-up. Only the 1st model.
Please help
I figured when I bound the second receiver it would show up as model 2 on the transmitter and I could add the name and set it up.....but nope. It still shows model 1(while bound) and I have stick control. I haven't tried turning on both drones to see if both operate on Model 1...assuming that should not be possible.
This is my 1st time trying to add a 2nd model to a single transmitter...I have a transmitter for each thing I fly....HA, a bit old school.
Trying to figure out how to get 1st drone as model 1 and 2nd drone as model 2. I need different settings for each. The manual for AT9S does not address 2nd, 3rd, 4th, etc. model binding and set-up. Only the 1st model.
Please help
