I'm upgrading my drone (I need an OSD so I don't over discharge another lipo).
I've bought a "Bardwell F4 AIO FC", I didn't realise it's got a built in PDB, I can take out my old PDB, that's fine.
The docs say if you're using a 4 in 1 ESC (which I am: 20A 4 in 1 ESC) then the battery should be connected to the ESC instead of to the FC.
But this ESC only has 5 wires going to the FC, I assume 1 to control each motor and a ground.
So should I connect the XT60 directly to both the ESC and the FC?
Or do I wire the XT60 to the FC and then connect the ESC's power wires to the FC somewhere (maybe I could use any of the ESC+ and ESC- pads)?
Thanks for your help,
Brad.
I've bought a "Bardwell F4 AIO FC", I didn't realise it's got a built in PDB, I can take out my old PDB, that's fine.
The docs say if you're using a 4 in 1 ESC (which I am: 20A 4 in 1 ESC) then the battery should be connected to the ESC instead of to the FC.
But this ESC only has 5 wires going to the FC, I assume 1 to control each motor and a ground.
So should I connect the XT60 directly to both the ESC and the FC?
Or do I wire the XT60 to the FC and then connect the ESC's power wires to the FC somewhere (maybe I could use any of the ESC+ and ESC- pads)?
Thanks for your help,
Brad.