So I am trying to connect my FS-I6B to my APM via the use of servo cables. I ordered some and then realized I had ordered the wrong type, I order M to F instead of F to F. However, I do have M to F jumper cables and was wondering if I would be able to put the F end of the servo cable into my radio and then put the jumper cables F end into the M end of the opposite side of the servo cable and then connect the other F side of the jumper cable into my APM. So essentially, this wiring would go:
Radio --> Female Servo Cable --> Male Servo Cable --> Female jumper cable --> Female jumper cable --> FC
It sounds like it would work but I am just unaware if the jumper cable would be able to transmit the signal coming from the signal wire on the servo connectors.
Thanks in advance.
Radio --> Female Servo Cable --> Male Servo Cable --> Female jumper cable --> Female jumper cable --> FC
It sounds like it would work but I am just unaware if the jumper cable would be able to transmit the signal coming from the signal wire on the servo connectors.
Thanks in advance.