Hi all,
Im new to the world of FPV and decided to build a drone. All was going well until I tried binding to the receiver.
I am using a radiomaster TX12 and a radiomaster R161 receiver.
There is only so much information out there about these receivers and I was just wondering if I could get some help.
Some work I have done so far concerning the receiver:
1. I have soldered the pos and neg, sbus and RSSI directly to the ESC stack and haven't bothered with the telemetry wire. Is this ok?
2. Once the USB is plugged into ESC, the receiver is lighting up and I am able to get it into binding mode.
3. Subtype of the receiver is LBT (EU)
tx12 issues that i have ran into:
1. When selecting the type of external RF, FrSkyX is not showing up on the radio, I have tried other types but with no success.
2. Status of the radio is `no telemetry'
3. I have tried updating the firmware to 64KB option and that isn't showing up on the radio.
Doing a bit of reading and looking at Youtube, the status of the radio should read the latest firmware? instead of `no telemetry', am I right in saying this?
Thanks
Im new to the world of FPV and decided to build a drone. All was going well until I tried binding to the receiver.
I am using a radiomaster TX12 and a radiomaster R161 receiver.
There is only so much information out there about these receivers and I was just wondering if I could get some help.
Some work I have done so far concerning the receiver:
1. I have soldered the pos and neg, sbus and RSSI directly to the ESC stack and haven't bothered with the telemetry wire. Is this ok?
2. Once the USB is plugged into ESC, the receiver is lighting up and I am able to get it into binding mode.
3. Subtype of the receiver is LBT (EU)
tx12 issues that i have ran into:
1. When selecting the type of external RF, FrSkyX is not showing up on the radio, I have tried other types but with no success.
2. Status of the radio is `no telemetry'
3. I have tried updating the firmware to 64KB option and that isn't showing up on the radio.
Doing a bit of reading and looking at Youtube, the status of the radio should read the latest firmware? instead of `no telemetry', am I right in saying this?
Thanks
