Recent content by dsmith76

I had the same problem on both my TinyHawk2 and 3. They would both only bind sporadically after constantly going through the bind procedures. I finally found a video /website that showed how to make a change on QX7, reverting back to prior firmware, or something similar. It completely solved the...

I use Velocidrone, Liftoff, and FPV Freerider, which is my favorite. It is simple and just 6 scenarios, but they give you all you need. Be patient, it takes a while to get the hang of it. Start off with beginner settings.

The TinyHawks are a great way to get started. Can be flown inside with limited risk of damaging it or the contents of your dwelling. Can fly it outside in light winds. Spend time on simulators first. FPV Freerider is simple and effective. Don’t try flying your DJI FPV in manual mode until highly...

Totally agree.

My solution was to buy the Eachine EV800D goggles which 6 months ago cost $100. Much better reception, easier to use, and now I can at least fly around the inside of my house. I could never get the DJI RE goggles to work well on analog. I use them now mainly on simulators fora very immersive...

Hi, I am fairly new to FPV. I have a couple of TinyHawk 2's that I like to practice with, mainly inside. I am interested in getting an analog receiver module for the DJI V2 goggles. Since the TinyHawk ii is likely to be the only analog drone I fly, I don't want to spend a large sum on the analog...

I have a GEPRC Rocket Plus and the SpeedX 1204 motors and props take M1.5 hex allen screws. The prop screws are 5mm and the motor screws are 6mm. Any recommendations on where to buy the screws? I Most screw assortments I see on Ebay/Banggood are M2. GEPRC does not sell them on their website. Thanks

Most everything I have know about FPV has been from forums and watching youtube videos. I watched a youtuber install the same antenna on a TinyHawk2 and after installing it he said to be sure and check the continuity because there is a positive and negative side to the antenna. Looks like he was...

I think the soldering job was fine--I checked the continuity with my multimeter, but I just finished re-soldering it anyway to make sure it was really solid, but it did not help. Probably your second prognosis is correct. I think I'll just order a new TinyHawk2. It was my first FPV quad and I...

Continuing with this situation, I received and installed the SMA adapter and it fits correctly on the DJI RE goggles and the RHCP Foxeer Lollipop antenna that I bought for the goggles. This antenna was actually recommended as an upgrade to some EMAX goggles I had (the goggles no longer work)...

Yes, sounds like that will work. Thanks for your assistance.

The antenna I bought and installed on the drone is a Lumenier Micro AXII Bare Wire 5.8GHz Antenna (RHCP. I have a Foxeer Micro Lollipop 5.8G RHCP antenna for the goggles. The goggles have a female plug, so I need an adapter with a RP-SMA Male Jack with pin, i.e. it must be threaded to screw into...

I want to be able to use the DJI RE Goggles for my analog drones. The antenna plug for the DJI RE goggles is LHCP, but my Tinyhawk 2 drone is RHCP, along with most other micro quads from what I've read. I broke the VTX antenna on the Tinyhawk 2 and replaced it with a Lumineer circular antenna...

I found the video antenna--the black one. Looks like it has been damaged, so I have been studying youtube videos on how to replace it. Thanks for your help.

I no longer use Facebook. Is there an alternative place to see what you are referring to?