Welcome to FPVDronePilots!
Join our free FPV drone community today!
Sign up

Recent content by Lightning111

  1. L

    Motors dont spin after FC realignment

    Hi, I have built a drone and found that on take off the drone flips over, by looking at JB video's I discovered that the FC orientation was incorrect so I changed the orientation in Beta Flight and confirmed that on moving the drone in pitch an yaw that the FC orientation was correct, but now...
  2. L

    Throttle Responce

    I have recently completed a build. On selecting Arm on my FS i6x the propellers spin at low revs as they should, on throttling up the motors respond with increasing rpm but on closing the throttle the motors don't respond and continue up to max rpm, the only way to stop them is by selecting the...
  3. L

    No Video on New Build

    Hi Drone Guy, I followed your advice and checked the integrity of my soldered joints and the UART settings both of which were OK. I ordered a replacement VTX which solved my problem. I guess that I must have connected power at some point without the antenna connected and fried the VTX though I...
  4. L

    No Video on New Build

    Hi Drone Guy thanks for your response. I am using BF release 4.2 1. My wiring is as the top diagram you forwarded except that on my drone the blue wire from TX Vid on VTX is connected to TX5 on my flight controller. In BF Ports tab UART 5 peripherals has VTX(IRC TRAMP selected. 2. Iset up my...
  5. L

    No Video on New Build

    I am new to the drone world and have just completed a build, I cannot get a signal between the Matek VTX HV and my Eachine ev800D goggles. Using Betaflight to program the VTX. I used IRC Tramp (EU) to programme the VTX Bands and Channels. The Matek HV VTX I have has LED's that correspond to the...