3D printed accessories

[Kilrah]

Couple of things I've printed that are useful:

Goggles battery holder

Longer controller replacement sticks for more precision, I used the "2.0" version

Also shortened the goggles battery cable

 

[leenanj]

Thank you, will print these up!

 

[Kilrah]

One more, charge plug to allow for charging a 2nd battery at the same time since the car charger I wanted to buy is unobtainium.
Would recommend using it with the charging hub to avoid risking to damage the connector on the batteries themselves, that's why I redesigned it from scratch instead of using the one someone posted but didn't work with the charging hub.

You need a power supply with current regulation to use the charging hub, the battery directly can be charged with any 6s-capable charger.

DJI FPV battery charge plug by Kilrah

Original version was too thick and not properly rounded to fit in the charging hub. Also the use of XT60 pins which are too big was too concerning to me about damaging the battery contacts and cause later issues on the aircraft.This uses M3 screws (2.9mm, original connector is a 2.8mm straight...

www.thingiverse.com

 

[Kilrah]

Prop cases: DJI FPV PROPELLERS CASE by maxcivi

Had to print the cover scaled 99% in X/Y so it holds better

 

[afreakofnature]

Very nice! I saw these on eBay too! Nobody’s going to buy them though because nobody wants to take the props off for transport j/k ???

 

[Kilrah]

I don't either, but backpacks that can fit the aircraft with the props on are big, rare and expensive

Had the props in the stock cardboard boxes but this at least takes a bit less room and is more convenient to put them in. Gonna need the room for an extra battery whenever it arrives

 

[Noobnoobnoob]

I don't either, but backpacks that can fit the aircraft with the props on are big, rare and expensive

Had the props in the stock cardboard boxes but this at least takes a bit less room and is more convenient to put them in. Gonna need the room for an extra battery whenever it arrives

Then unless you have a the aircraft set in tightly so it doesn't move you will bend the props, pretty expensive props. I'll take the time

 

[Noobnoobnoob]

If you look around a few holders come with a "chord reel" for lack of a better description, that keeps the chord neatly wrapped ano out of the way. I rushed and bought the battery holder before all these other options, and mine is sized for the factory strap, but I use a fat strap, so it doesn't stay for storage, though it works well enough on the head. I am using the "pocket" on the strap to hold the chord with a mini battery strap around it for insurance.

 

[Oneball1971]

Couple of things I've printed that are useful:

Goggles battery holder

Longer controller replacement sticks for more precision, I used the "2.0" version

Also shortened the goggles battery cable

View attachment 5036

View attachment 5037

View attachment 5038

Was it easy enough to shorten the lead. Looks a neat job

 

[Kilrah]

Yes, just cut and solder the 2 wires.