DJI Avata

[bobs stuff]

Another Problem with Avata
I have an Avata with the motion 2 controller. Pushing the button 2 times the motors start up normal in the idling speed.
All is normal when pushing the toggle switch up SLIGHTLY, motor speed increases slightly.
Moving the toggle switch a tiny bit more the motors increase to full speed and cannot be stopped by moving the toggle switch to the
fully down position. The motors will continue to run at MAX speed for about 10 seconds. After 10 seconds with the toggle switch fully down the motors will stop. I have to hold down the drone with my hand or
it will be gone out of sight in a few seconds. Any thoughts on this malfunction ?

 

[Kilrah]

Follow the instructions and don't touch the joystick until after takeoff.

 

[bobs stuff]

Follow the instructions and don't touch the joystick until after takeoff.

Got the reply but nothing for the instructions.

 

[bobs stuff]

Got the reply but nothing for the instructions.

I think I was using the joy stick by mistake instead of holding the button for a second or two to get it going. I am a DJI newbie. Will give at try when I get back in town. Thanks for the reply.