- Joined
- Apr 28, 2020
- Messages
- 82
- Reaction score
- 5
- Age
- 62
Thank you for the advice. I’ll check again, but I don’t think this is the case with mine.This issue has be reported by a small group of people. It appears that the pin alignment is off on some units and therefore do not properly connect to the TX module in the JR bay. You can take a look at the pins in the JR bay and make sure they are perfectly perpendicular to the back. A slight bend upwards can result in the pins connecting in the wrong holes in the TX module (with the top pin going over the last hole).
This is likely your issue. Take a picture of your JR bay and I can likely confirm this for you.
If it is, I will report back.