Hello,
I have an Protek35. Was analog. Never used. Removed analog VTX and put caddx Vista in. I have done it before on 3 others Whoops. One also being a Protek35.
I have bound goggles en black DJI DIGITAL CONTROLLER. Have video in goggles . Have OSD. Have battery voltage. The Beast F7 board is the original as mountd bij Iflight. Controller and caddx DO connect. ( Green led)
I see it in Betaflight. Is see movement so sensors tc work.
I can NOT get any receiver channel response. I have used MSP 1 and Uart2 for Sbus as in the wiring diagram.
It almost looks like the SBUS yellow wire is not connected but is was....
I will open the whoop up to check again
But......Where else can I look. WHAT els can i try??
Thanx
Sparky
I have an Protek35. Was analog. Never used. Removed analog VTX and put caddx Vista in. I have done it before on 3 others Whoops. One also being a Protek35.
I have bound goggles en black DJI DIGITAL CONTROLLER. Have video in goggles . Have OSD. Have battery voltage. The Beast F7 board is the original as mountd bij Iflight. Controller and caddx DO connect. ( Green led)
I see it in Betaflight. Is see movement so sensors tc work.
I can NOT get any receiver channel response. I have used MSP 1 and Uart2 for Sbus as in the wiring diagram.
It almost looks like the SBUS yellow wire is not connected but is was....
I will open the whoop up to check again
But......Where else can I look. WHAT els can i try??
Thanx
Sparky
