Recent content by Eachine98379872

I also have this problem with my Cvatar. Has anyone solved it?

Yep. I'll try everything on Uart1 again and see what I can do. I reckon its some really small setting that I have no idea about.

I want to do this aswell because my ESC keeps breaking. How do you do it? There dosen't seem to be much online from other people doing the same thing.

I tried all the things in the video. No Joy. The flight controller is one of these: eachine.com/Eachine-Cvatar-F722-Mini-3-6S-Flight-Controller-OSD-BEC-compatible-DJI-FPV-Air-Unit-for-142mm-3-Inch-Cinewhoop-Duct-FPV-Racing-Drone-p-2239.html I've attached a screenshot of the wiring diagram...

I have brought a new drone and Im trying to bind a FS A8S to my FS-i6X both Flysky. When I plug the drone into betaflight it dosent show anything moving on the reciver tab. I have bound it and the red light is solid on the RX when I turn on the TX showing that it is connected. Any help would...

I have the FlySky i6 FS-i6x. It does the job and it dirt cheap but, as I'm sure everyone else on the forum will tell you, it isn't the best...

This is the one I keep seeing. Is it just a case of soldering it onto the correct contacts on the ESC? FlySky 2.4G 6CH FS-iA6B Receiver PPM Output With iBus Port

What sort of thing would fit that category? I want to spend about £100-120 which I know is cheap. I also want to use my 4s batteries because money for buying new ones :) I know MrMund recommended the TinyHawk which looks like a good option. How do I make sure it works with my remote though?

Thank you I'll have a look at those. With the RX can I buy any RX that is compatible with my controller and solder it on? I'm getting pretty stuck with which I'll I need and what will work with what

I continually crash and break by Eachine Wizard so I was thinking of getting the Eachine Cvartar to practice on. It looks a lot less breakable because of the bumpers. Two questions. Do you think its worth getting one? How do I know what reciver to get? I have a Flysky FS-I6 TX already...

I tried that but it still keeps falling out. It doesn't feel like its locked in or anything at all - theres literally nothing to stop it coming back out. Cheers

I had to replace my VTX on my Eachine Wizard X200s because of a big crash. It came with a new cable that connects the VTX to the antenna however I cant make the connector stay in on the VTX side. I've added a photo its the connector thats gold that I'm on about. What am I doing wrong? This is...

If I reterminate the balance connector though is it safe or would the cells have been damaged by the current? Thank you

Had my first lipo fire today. No idea how but the balance connector came off and all the wires touched causing the isolation to melt and catch fire on one of the leads (see photo). I reckon it was pulled against the body of the drone or something cus it definitely didn't go through the...

So I was flying the drone and the balance connector went through the rotors causing some of the leads to short. Seeing as I need a new set of underwear after the experience do I need to buy a new battery aswell? All the cells are at a good voltage - about 3.7V each so can I just resolder them...