Heyfirst off, take those props off when on the bench please!! (giving me heebejebies)
Is battery voltage up to par?
Has this configuration flown before you put it away for a time?
Do the motors/esc test out in betaflight?
Do you have the TX on and green showing on the RX?
just a few first questions to get started. I assume you've covered these.. but just asking.
Yup checked them allDid you check all your switches? Looks like you have an alarm going off
It does this when you plug in the USB as well correct? Is it displaying anything in the goggles?
If my quad was doing this I would backup my settings in betaflight and reflash
Yeah, plug in to USB and see, and I assume it will alarm. Once in betaflight you'll see a version in the upper left hand corner. You can also go to the CLI and type in "Version" and it will tell you what you need to flash.I haven’t plugged it in yet
I’m not betaflight savy
But I did have these settings saved in betaflight by a fellow member
I’m not too sure how to reflash
I will try later
Yeah, plug in to USB and see, and I assume it will alarm. Once in betaflight you'll see a version in the upper left hand corner. You can also go to the CLI and type in "Version" and it will tell you what you need to flash.
So I plugged it into betaflightIt does this when you plug in the USB as well correct? Is it displaying anything in the goggles?
If my quad was doing this I would backup my settings in betaflight and reflash
Try turning your accelerometer completely off. You can be in air mode but still have it on horizon
Yeah turn accelerometer off in BF. Whilst you’re in there can you see the modes switching on the modes tab to make sure you have your transmitter set up correctly?That’s what it sounds like it’s doing
Do this in betaflight
GreatYeah turn accelerometer off in BF. Whilst you’re in there can you see the modes switching on the modes tab to make sure you have your transmitter set up correctly?
Like this: