Hello, I hope I am posting in the correct place.
Yesterday I updated my FS-i6 firmware for 14 channels and RSSI.
I went out flying today, and was able to see exactly where my signal has been cutting out.
With my X6B receiver, I am losing signal around 150 meters away. I have seen people achieve 1.5km with the same setup, so would expect it to perform better. I have attached pictures of my setup for reference.
I have opened up my transmitter, and both antennae are connected properly.
The receiver is mounted using a 3D printed part, and secured with a zip tie.
Aside from this, I ordered two new antennae for my transmitter. This may help with the problem.


Any help or ideas would be greatly appreciated
Yesterday I updated my FS-i6 firmware for 14 channels and RSSI.
I went out flying today, and was able to see exactly where my signal has been cutting out.
With my X6B receiver, I am losing signal around 150 meters away. I have seen people achieve 1.5km with the same setup, so would expect it to perform better. I have attached pictures of my setup for reference.
I have opened up my transmitter, and both antennae are connected properly.
The receiver is mounted using a 3D printed part, and secured with a zip tie.
Aside from this, I ordered two new antennae for my transmitter. This may help with the problem.


Any help or ideas would be greatly appreciated