Like to say what's up to everyone. Just a little back ground on myself. Retired military after 22 years and took on a civilian position with the Department of Defense. Civilian life is great! I was recently into RC cars, everything from Gas to electric and on road to off road. About 2 years ago I got into drones. My first one was an A.R 2.0 drone then to a Yuneec Typhoon and now building a race drone. I think my next will be a DJI Mavic. I have a birthday coming up and Christmas is around the corner so maybe the wife has been listening to my hints.
OK, so here is my issue. I purchased the Lumenier QAV250 airframe and I decided to go with the makerfire 12A ESC over the Lumenier ESC due to reviews I read. My question is the lumenier has 3 control wires the the - and a control wire to solder to the Lumenier Fury PDB. The Makerfire only has 2 control wires one orange one brown. How do I install this since there are only 2 wires and the PDB has connections for 3 wires?
Bryan
OK, so here is my issue. I purchased the Lumenier QAV250 airframe and I decided to go with the makerfire 12A ESC over the Lumenier ESC due to reviews I read. My question is the lumenier has 3 control wires the the - and a control wire to solder to the Lumenier Fury PDB. The Makerfire only has 2 control wires one orange one brown. How do I install this since there are only 2 wires and the PDB has connections for 3 wires?
Bryan
