New builder troubles

[NavyQUAD250]

PID Settings are one thing but oscillating causes throttle runaway and low stick drop out when Power cut completely out. Anyone have this happen? It’s a new arf and I like it just can’t hover to smooth landing runs one direction, up.

 

[theGreenOrange]

Hi, Is airmode on? What version of betaflight you running? Airmode used to do some really weird stuff when landing. Also these things generally are not good at still hovering, especially close to the ground.

 

[NavyQUAD250]

First thanks for trying to help me. The air mode is cut on and off with nothing noticed. Matter of fact I changed it to on by training lever, meaning o have pull the switch to cut it off.

 

[VirtueViolater]

Sounds like vibrations are getting to your fc, is it soft mounted?

 

[NavyQUAD250]

I am running version 3.2.2
PID settings:
Roll 40. 15. 10
Pitch 50. 30. 10
Yaw. 60. 40.

Rc rate 1.74. Over. 2.00
Super .50
.55
.12

Expo
.12. Over .10

 

[NavyQUAD250]

Angle strength 75. Over 40. Transition 40
Limit 55 sensitivity 40

Throttle mid .50
TPA .15

 

[NavyQUAD250]

Fc is plastic stud mounted

 

[VirtueViolater]

No "O" rings or any other kind of rubber? If not you can add O rings under and over fc. You can also add soft motor mounts. This problem is common with first time builds.

 

[VirtueViolater]

Also, if using airmode, best to have it on a switch so you can turn it off as you land

 

[VirtueViolater]

Are your props turning when you arm? if not, you want to set up an idle when armed to fix dropout

 

[NavyQUAD250]

Sounds like vibrations are getting to your fc, is it soft mounted?

Im new to this but plastic studs

 

[NavyQUAD250]

Are your props turning when you arm? if not, you want to set up an idle when armed to fix dropout

Now that makes since

 

[NavyQUAD250]

Are your props turning when you arm? if not, you want to set up an idle when armed to fix dropout

I will speed up the throttle trim but it will not arm after too high setting, right?

 

[NavyQUAD250]

Check back tomorrow night I will post results

 

[VirtueViolater]

I will speed up the throttle trim but it will not arm after too high setting, right?

In Betaflight under configuration I think, theres a switch to turn idle on, or off. I use a high idle instead of airmode

 

[VirtueViolater]

I will speed up the throttle trim

Its not trim, its in betaflight

 

[NavyQUAD250]

Its not trim, its in betaflight

On configure page or PID ,

 

[VirtueViolater]

Not pids. You may not need to mess with pids yet.

 

[NavyQUAD250]

Not pids. You may not need to mess with pids yet.

Tried to add picture but having trouble. But minimum throttle is 1095 maybe why it runs away

 

[VirtueViolater]

Watch this, it will help lots