Hey everyone!
I'm fairly new to all this so I hope you can help me.
I have a BETAFPV 95x V3 Pusher VTX with Crossfire. The FC burned several weeks ago because some fabric got in one motor. I removed all the fabric, replaced the FC and connected everything like it was before and now comes my problem.
I flashed the FC with the newest firmware via betaflight. My radio (TX16S) is bound to the transmitter and has a green light (have updated to the newest TBS firmware). As far as i know i have to use the uart3 for the radio and i selected the CRSF protocol. I saved and rebooted everything but when i go to the receiver tab and move my sticks on the radio, nothing will happen. I don't know what I can do to make it work and i need that drone up in the air in one week.
On my tiny whoop, the motors did move a bit when I started it, does that every drone? Because the motors of the pusher don't move when I start it.
My Dump: Dump
Thanks in advance
I'm fairly new to all this so I hope you can help me.
I have a BETAFPV 95x V3 Pusher VTX with Crossfire. The FC burned several weeks ago because some fabric got in one motor. I removed all the fabric, replaced the FC and connected everything like it was before and now comes my problem.
I flashed the FC with the newest firmware via betaflight. My radio (TX16S) is bound to the transmitter and has a green light (have updated to the newest TBS firmware). As far as i know i have to use the uart3 for the radio and i selected the CRSF protocol. I saved and rebooted everything but when i go to the receiver tab and move my sticks on the radio, nothing will happen. I don't know what I can do to make it work and i need that drone up in the air in one week.
On my tiny whoop, the motors did move a bit when I started it, does that every drone? Because the motors of the pusher don't move when I start it.
My Dump: Dump
Thanks in advance
